Britax safe-n-sound maxi lite Instructions For Installation & Use page 28

HOW TO INSTALL CHILD HARNESS
USING LAP ONLY SEAT BELT OR CONVERTED LAP-SASH SEATBELT
WITH THE CHILD HARNESS
Install the Child Harness to the booster seat and anchorages as detailed previously (page 45- 46). Install
the booster seat into the vehicle. Ensure the top tether strap is attached to the vehicle upper anchorage
and adjusted correctly. With the vehicle seatbelt converted (if necessary) ready for use, thread the lap
seatbelt through the Child Harness strap loops as shown.
NOTE: Seatbelt extenders should not be used if the
seatbelt is not long enough to fit around the child. If
a seatbelt extender is used then the seatbelt buckle
must not be in contact with the child.
Use the child harness as detailed on page 55-57.
54
Instructions for Installation & Use - Series No. 8100/A/2013
Child Harness
strap loops
SLIDEGUARD™
Clip
HOW TO INSTALL CHILD HARNESS
USING THE CHILD HARNESS
Connect the Harness to the VERSATETHER™ Catch on the booster seat detailed on page 45 to 46.
A. With the child seated, place the Child Harness straps over each shoulder.
B. Feed the right hand strap (loop end) into the cross strap loop to connect the two sides.
C. Feed the adult belt (lap belt or converted lap/sash) through the harness strap loops, ensuring that the
cross strap loop does not disconnect. Ensure there are no twists in the Child Harness, cross strap and
seatbelt.
1. Vehicle Upper Anchorage Fitting
2. VERSATETHER™ Catch on Booster Seat
3. Child Harness Attachment Clip
4. Right Hand Harness Strap
5. Adjuster (under cover)
6. Harness Strap Loop
7. Cross Strap Loop
8. Cross Strap
Instructions for Installation & Use - Series No. 8100/A/2013
2
3
Pull to remove
4
slack
5
6
8
7
6
1
55