Britax safe-n-sound maxi lite Instructions For Installation & Use page 27

HOW TO INSTALL CHILD HARNESS
FITTING THE GATED SLIDE TO THE LAP-SASH SEATBELT
A. Hold the lap and sash straps together and fold as shown.
Slide the inner strap into the Gated Slide followed by the
outer strap.
IMPORTANT :
Face the hollow side of the Gated Slide and the inner
strap towards the child. Do not use Gated Slide for any
other purpose.
B. The two straps should slide freely in the Gated Slide slot.
C. Repeat previous step A for the other slot in the Gated
Slide.
52
Instructions for Installation & Use - Series No. 8100/A/2013
Outer
Inner
Strap
Strap
Faces
towards
Child
A
B
Ensure the lap portion of the seatbelt
is nearest to the child
C
HOW TO INSTALL CHILD HARNESS
D. Feed the straps through the gated slide to remove any
slack. This has now converted the lap-sash seatbelt so
it will act like a lap only seatbelt.
E. Ensure all slack is removed from the converted lap belt.
NOTE: TO ENSURE CORRECT CONVERSION OF LAP-SASH SEAT BELT TO LAP SEAT BELT
FOLLOW THESE STEPS.
IMPORTANT :
The Gated Slide must be removed from the seat belt if the booster seat and child harness are no longer
used in the car so that other users can use the seat belt as a lap-sash seat belt.
A seat belt extender should not be used if the seat belt is not long enough to secure the child. If a seat
belt extender is used then the buckle must not be in contact with the child.
Instructions for Installation & Use - Series No. 8100/A/2013
Hollow side
towards child
D
Loop on top
Strap
portion
Hollow side towards
Lap portion
the child
53