Britax safe-n-sound maxi lite Instructions For Installation & Use page 13

HOW TO INSTALL
D. Lengthen the top tether strap and connect the attachment
clip to the car's upper anchorage point making sure to
remove as many twists as possible.
To lengthen the top tether strap, fully press adjuster button
(A) while pulling top tether strap (B) to slacken as shown
left.
Refer to your vehicle owner's manual for the location of the
upper anchorage point in the car. If the vehicle is not fitted
with a child restraint upper anchorage point then refer to
page 68 to 71 for the installation of the upper anchorage
point provided with this child restraint.
E. Push down on the restraint to compress it into the vehicle
seat. Whilst compressed in the seat, pull on the lap portion
to remove all slack from the belt. Pull the sash belt and
allow excess belt to feed back into the retractor. Ensure all
slack is removed from the lap and sash belt.
F. The restraint should be held firmly against the vehicle
seatback.
CAUTION:
CHILDREN CAN BE INJURED OR RESTRAINTS AND TOP TETHER STRAP DAMAGED BY
UNSECURED CARGO IN A COLLISION. SECURE OR REMOVE HAZARDOUS CARGO BEFORE
USING THIS CHILD RESTRAINT.
24
Instructions for Installation & Use - Series No. 8100/A/2013
Attachment Clip
Car's Upper Anchorage Point
Fully press Adjuster Button (A)
while pulling top tether strap (B)
to lengthen.
A
B
Pull
PUSH
G. Pull the top tether adjustment strap (C) to remove all slack
but do not tighten.
Always secure the loose end of the top tether strap to
prevent it hanging out of the car or being accessible to the
child. Fold up excess strap and use pocket to store excess
strap behind seat.
EXPLANATION NOTE: This method of installation ensures
good seatbelt tension, even with the child in the seat. We
recommend that as your child grows, you should periodically
check the seatbelt and top tether tension to ensure that (a)
the car seatbelt has not slackened off and the top tether
strap is too tight.
IMPORTANT :
Always ensure that the car seatbelt is firmly restraining the child restraint on the vehicle seat and
ensure the slack is removed from the tether strap.
Always secure the loose end of the top tether strap to prevent it hanging out of the car or being
accessible by the child. Do not use the child restraint where this strap may fall into a split in the
seatback or off the side of the seat.
Make sure cup holders (if fitted) do not interfere with closure of the car door.
ALWAYS attach top tether hook and remove slack.
Instructions for Installation & Use - Series No. 8100/A/2013
HOW TO INSTALL
A
C
Pull Adjustment Strap
to remove slack
Roll up excess
strap and store
in the pocket
attached to the
cover.
25