Diskette Drive A Removal
1. Set the Power switch on the system unit (and
expansion unit, if attached) to Off.
2. Set the Power switches on all attached
devices to Off.
3. Unplug the power cord of the system unit
(and expansion unit) from the outlet.
4. Disconnect all cables from the rear of the
system unit.
5. Remove the cover of the system unit (5-100-2).
6. Disconnect the signal cable from the
diskette-drive logic board.
Note: You have to remove some of the option
adapters to remove the diskette-drive
mounting screws.
5-601-2 Maintenance Information