Display Adapter 3200 - IBM 3270 Maintenance Manual

Display Adapter 3200
You have entered this PIC because you have a
32XX Diagnostic error or have identified a
display problem. If your display is blank,
unreadable, or unstable, when POST is run or
when the Diagnostics diskette is loaded, go to
"Display Check" on page 3-25-1.
If the Diagnostics diskette is already loaded, exit
to the main menu (shown below) and begin on
the next page. Otherwise, follow the steps below
to load the Diagnostics diskette.
1. Set the system unit Power switch to Off (0).
2. Insert the diagnostic diskette into drive A and
push the load lever down.
3. If you have an expansion unit, set its Power
switch to On
(I).
4. Set the Power switch on the system unit to
On (I) and wait for the Diagnostics menu to
appear.
CONTINUE
October
1984 3-3200-1