Introduction
Slide
Switch
This section describes the switch setting for the
System Board and the various option adapters
that can be installed in the IBM 3270 Personal
Computer.
Warning: Before you change any switch
settings, make a note of how the switches are
presently set.
Set a rocker switch by pressing down the rocker
to the desired position. Push a slider switch to
the desired position.
The following notation is used throughout this
section:
o
Is used to indicate a switch setting should·
be in the
orr
position.
1
Is used to indicate a switch setting should
be in the On position.
x
An "x" is used when a setting is not
important for the discussion.
or
Rocker
Switch
Ballpoint
Pen
6-2 Maintenance Information