Backrest - ProActiv RAPTOR 4all Operating Instructions Service Booklet

Compact bikes
Table of Contents

Advertisement

Subject to changes to the links provided by the
component manufacturers.

17 Backrest

The product can be equipped with a fixed or an
adjustable backrest. When equipping with a
fixed backrest there are no options for
adjustment.
When equipping with an adjustable backrest,
this can be adjusted in its inclination and
longitudinal positions.
In order to adjust the angle of the adjustable
backrest, open the .quick release lever on the
backrest support. Then the backrest can be
moved forwards of backwards. Once the
desired angle of the backrest is set, hold the
backrest in this position and then close the
quick release lever again.
Quick
release lever
open
Figure 19: Quick release lever for adjusting the
backrest angle opened
Figure 20: Quick release lever for adjusting the
backrest angle closed
After adjusting the angle of the backrest
each time, check that the backrest is firmly
attached in its position. If necessary the
15
Backrest support
Quick
release lever
closed
Operating instruction RAPTOR 4all & 4you
tension can be adjusted by turning the quick
release lever clockwise.
The longitudinal positioning of the
adjustable backrest (or distance for the
backrest to the pedal bearing) can be carried
out by undoing one M6 clamp screws (AF 5
mm) each on the right and left side of the
product frame. After undoing a total of two M6
clamp screws (AF 5 mm), both clamps on the
product frame can be moved to the desired
position.
Longitudinal positioning of
the backrest
Terminal clamp
Figure 21: Clamp for the longitudinal positioning of
the backrest
Figure 22: Longitudinal adjustment of the backrest
via M6 fixing screws and clamps on the frame of the
product
In doing so, you have to ensure that the
clamps on the right and left side have to be
positioned at the same height of the product
frame.
Once the desired longitudinal position of the
backrest has been found, the two M6 clamp
screws (AF 5 mm) are tightened to 7 Nm again
and secured using screw locking fluid.
M6 clamp screw for
positioning
lengthwise

Advertisement

Table of Contents
loading

This manual is also suitable for:

Raptor 4you

Table of Contents