Collision Guard; Collision Guard Mount; Mounting The Collision Guard - ProActiv RAPTOR 4all Operating Instructions Service Booklet

Compact bikes
Table of Contents

Advertisement

Figure 27: Quick release lever opened for adjusting
the neck rest angle
After every adjustment, check that the
neck rest is firmly attached in its position. If
necessary the tension can be adjusted by
turning the nut of the quick release lever
clockwise until it reaches the end stop.
Nut of the quick
release lever
Figure 28: Nut of the quick release lever

20 Collision guard

Figure 29: Collision guard
17
Operating instruction RAPTOR 4all & 4you
Top quick
release lever
opened

20.1 Collision guard mount

The removal of the collision guard is carried
out via the quick pins. To do this, press the
locking knobs of the quick pins on the right and
left and pull these out. Then the collision guard
can be pulled out.
Locking knob
Figure 30: Quick Pin with locking knob for removing
the collision guard
After removing the collision guard, the
Quick Pins can then be inserted in the
boreholes of the inlets or the collision guard to
prevent losing them.

20.2 Mounting the collision guard

Inlet
Figure 31: Inlet of the collision guard with borehole
For mounting the collision guard, the collision
guard is pushed onto both inlets to the stop.
Then the Quick Pins are inserted back into the
boreholes of the collision guard and inlet with
the locking knobs pressed. In doing so, take
care that the locking knob jumps back out
completely after inserting.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Raptor 4you

Table of Contents