Table of Contents
Advertisement
23.3 Adapting the drive unit
To adapt the drive unit to the chassis, place
the chassis on the chassis stand and operate
the parking brake.
Chassis stand
Figure 43: Chassis on the chassis stand
Accurately place the adapter plates of the
chassis and drive unit on top of one-another
and insert the ball lock pins into the top
opening of the adapter plates on the left side in
the direction of travel. In order to allow these to
be inserted, the orange surface on the handle
of the ball lock pin must be pressed in, the
drive unit aligned straight and the drive wheel
is raised a little.
Adapter plates
resting accurately on
Lift the
top of one-another
drive wheel
Figure 44: Adapter plates resting accurately on top
of one-another
21
Operating instruction RAPTOR 4all & 4you
Ball lock pin
inserted
Figure 45: Ball lock pin in the top opening of both
adapter plates
Now the eccentric pin must be inserted in the
bottom opening on the left side in the direction
of travel, and the lever of the eccentric pin
must be turned upwards approx. 90° counter-
clockwise. Finally, the securing cord is hung
onto the lever of the eccentric pin.
Eccentric pin
inserted in the
adapter plate
Figure 46: Eccentric pin inserted
Lever of the eccentric
pin closed (turned
upwards)
Figure 47: Drive unit adapted completely
Orange
surface on
the handle
Securing
cord hung on
Advertisement
Table of Contents
