Pronto M50 Owner's Operator And Maintenance Manual page 72

SECTION 11—BATTERIES
NOTE: For this procedure, refer to FIGURE 11.5.
NOTE: The ON/OFF LED indicator light and the charger LED indicator light are located on the
top of the charger on the rear of the wheelchair. Open rear shroud to view indicator lights.
1. Plug the female connector of the AC power cord (supplied) to the AC receptacle on
the charger and plug in the male connector on the AC power cord into the wall outlet.
2. The On/Off LED indicator is blinking RED, this is abnormal. Unplug AC power cord
from the on-board battery charger and wall outlet. Contact Invacare at the number
listed on the back page of this manual.
3. When the On/Off LED indicator light is OFF, charger is off.
4. When the Charge LED indicator light is YELLOW, the batteries are charging.
5. When the Charge LED indicator light is solid GREEN, the batteries are FULLY
charged (as their condition will allow). At this point, the charger automatically stops
charging.
6. When charging is complete, unplug the male connector of the AC power cord from the
wall outlet and then unplug the female connector of the AC power cord from the AC
receptacle on the charger.
DO NOT operate wheelchair with AC power cord attached to the wheelchair.
® ™ ™
Pronto M50 , M51 and M61
WARNING
™ ™ 72
with SureStep Part No. 1125085