Information Gauge Display - Pronto M50 Owner's Operator And Maintenance Manual

Information Gauge Display

Located on the front of the joystick housing, it provides the following information to the
user on the status of the wheelchair -
1. Power is On.
2. True state-of-battery-charge, including notification of when the battery requires
charging:
A. GREEN LED is lit, indicating well charged batteries.
B. Only AMBER LEDs are lit, indicating batteries are moderately charged. Recharge
batteries before taking a long trip.
C. Only RED LED is lit, indicating batteries are running out of charge. Recharge
batteries as soon as possible.
The Information Gauge display also serves as a system diagnostic device when a fault is
detected by the control module. A specific number of flashes of the LEDs indicate the type
of fault detected. Refer to the following table of the diagnostic indications of the
wheelchair status.
DISPLAY
INVACARE
INVACARE
INVACARE
INVACARE
Part No. 1125085
DESCRIPTION
All three (3) LEDs are off.
All three (3) LEDs are on.
RED LED is flashing.
Left to Right "chase" alter-
nating with steady display.
35
SECTION 5—WHEELCHAIR OPERATION
DEFINITION
Power is Off.
Power is On.
Battery charge is low.
Joystick is in program-
ming, inhibit and/or charg-
ing mode.
® ™
Pronto M50 , M51
COMMENTS
Fewer than three (3)
LEDs on implies reduced
battery charge.
The batteries should be
charged as soon as possi-
ble.
The steady LEDs indicate
the current state of the
battery charge.
™ ™
and M61 with SureStep
™