Section 9-Front Riggings; Installing/Removing Front Riggings; Installing - Pronto M50 Owner's Operator And Maintenance Manual

SECTION 9—FRONT RIGGINGS
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
DO NOT stand on the front riggings, otherwise damage may occur. When getting
in or out of the wheelchair, make sure that the footplates on the front riggings are
in the upward position or moved out of the way.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the OFF position.

Installing/Removing Front Riggings

If front riggings are used, then the seat MUST be adjusted to the highest mounting
position - otherwise damage may occur.
NOTE: For this procedure, refer to FIGURE 9.1.

Installing

1. If necessary, remove the footboard. Refer to Removing/Installing the Footboard
Assembly on page 50.
2. Turn front rigging to the side (open footplate is perpendicular to wheelchair) and
position mounting holes in the front rigging hinge plates with hinge pins on the
wheelchair frame.
3. Install the front rigging hinge plates
onto the hinge pins on the wheelchair
frame.
4. Push the front rigging towards the
inside of the wheelchair until it locks
into place.
NOTE: The footplate will be on the inside of the
wheelchair when locked in place.
5. Repeat STEPS 1-4 for opposite side of
wheelchair.
Part No. 1125085
SECTION 9—FRONT RIGGINGS
WARNING
CAUTION
Hinge
Pins
Front Rigging
Release Lever
FIGURE 9.1 Installing/Removing Front
53 ®
Pronto M50
Telescoping
Front Rigging
Support
Front Rigging
Hinge Plate
Riggings
™ ™ ™
, M51 and M61 with SureStep
™