SECTION 10—TOP SHROUD AND WHEELS
Right Motor
Release Lever
Shown
Disengaged
Engaged
NOTE: Office style van seat is shown.
Standard van seat adjusts the same way.
FIGURE 10.2 Engaging/Disengaging Motor Release Lever
Replacing Front/Rear Caster Assemblies
NOTE: For this procedure, refer to FIGURE 10.3.
NOTE: Front and rear caster assemblies are replaced in the same manner.
NOTE: When replacing the front/rear caster assemblies, it is necessary to brace the caster
assemblies to prevent the wheel from spinning.
1. Remove the mounting screw, two (2) washers, and locknut that secures the caster to
the fork.
2. Remove the caster and discard.
3. Secure new caster to fork with existing mounting screw, two (2) washers and locknut
(FIGURE 10.3). Securely tighten.
FIGURE 10.3 Replacing Front/Rear Caster Assemblies
®
™
™
Pronto
M50
, M51
and M61
Mounting
Screw
Washer
™
™
62
with SureStep
Locknut
Washer
Caster
Part No. 1125085