Section 8-Footboard Assembly; Removing/Installing The Footboard Assembly; Removing; Installing - Pronto M50 Owner's Operator And Maintenance Manual

SECTION 8—FOOTBOARD ASSEMBLY
SECTION 8—FOOTBOARD
ASSEMBLY
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that On/Off
switch on the joystick is in the Off position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
LIMITED CLEARANCE BETWEEN FOOTBOARD AND CASTER - The user's feet
MUST remain on the footboard while operating the chair. If the user's feet are
allowed to rest off the side of the footboard they may come in contact with the
caster possibly resulting in injury.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 8.1.

Removing

1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls are engaged with the outer edge of the tube - otherwise,
injury and/or damage may result.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole
in the wheelchair frame aligns with the desired mounting hole in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin in. Ensure
that the detent balls are engaged with the outer edge of the tube (Detail "A" of
FIGURE 8.1).
® ™ ™
Pronto M50 , M51 and M61
WARNING
WARNING
™ ™ 50
with SureStep Part No. 1125085