Prepare For Installation - Tesla WALL CONNECTOR Installation Manual

Step-by-Step Installation Instructions

Prepare for Installation

Follow these instructions to remove the cover
and route the service wiring into the Wall
Connector.
1. Use a T10 Torx driver to remove the screw
at the bottom of the outer cover. Carefully
disengage the snaps on the sides and top
using a flathead screwdriver and
completely remove the cover. Save the
screw and cover for reassembly.
2. Use a T20 security pin Torx driver to
remove the six screws on the sealing
cover. Carefully remove the sealing cover
and disconnect the ribbon cable. Save the
screws and cover for reassembly.
16
Caution: Do not allow the sealing
cover to hang from the ribbon cable.
Doing so can damage the ribbon
cable or its connectors.
3. For top entry configuration, install the
wiring to the terminal block in the top
entry bracket as shown in Connect the
Wiring on page 17, then return to this
section and proceed to the next step. For
back or bottom entry configurations, skip
to the next step.
4. Place and hold the Wall Connector on the
bracket, ensuring that all four mounting
tabs are properly aligned.
5. Use a T20 Torx driver to install the two
top housing mounting screws. Push the
cosmetic screw covers into place.
6. Use a T20 Torx driver to install the two
bottom housing mounting screws. Push
the cosmetic screw covers into place.