Install The Top Entry Bracket For Top Entry Wiring - Tesla WALL CONNECTOR Installation Manual

Install the Top Entry Bracket for Top
Entry Wiring
The top entry bracket enables you to route the
service wiring into the Wall Connector
enclosure from the top of the enclosure, as
shown below.
1. Use the cardboard template and a level as
a guide to mark the location on the wall
for the mounting screws.
• Use a level to ensure that the marks
are perfectly vertical.
• Space the holes 155 mm apart.
• Position the bracket so that the Wall
Connector is located at a maximum of
150 cm from floor level. The minimum
height is 45 cm if mounting indoors,
and 122 cm if mounting outdoors.
Note: Ensure that the minimum and
maximum height of the bracket is carefully
selected. It should be installed out of the
way of any reasonably foreseeable
impacts.
2. (Optional) There are two additional
mounting holes. To use these holes, use a
flat-head screwdriver to knock-out the
plastic that is closing the holes. These
holes are spaced 70 mm apart.
Step-by-Step Installation Instructions
Step-by-Step Installation Instructions
3. Attach the bracket using fasteners that
are appropriate for the type of wall
material, drilling pilot holes if necessary.
Use the supplied screws only if mounting
the bracket directly to a wooden stud. If
mounting to another type of wall (hollow,
masonry, etc.), use fasteners that are long
enough to securely anchor the Wall
Connector and can hold at least 36 kg.
15