Install The Low Profile Bracket For Rear Or Bottom Entry Wiring - Tesla WALL CONNECTOR Installation Manual

Step-by-Step Installation Instructions
Install the Low Profile Bracket for
Rear or Bottom Entry Wiring
Use the low profile bracket, shown below, to
wire the Wall Connector from the rear or
bottom.
1. Use the low profile bracket as a guide to
mark the location on the wall for the
mounting screws.
• Use a level to ensure that the marks
are perfectly vertical.
• Space the holes 114 mm apart.
• Position the bracket so that the Wall
Connector is located at a maximum of
150 cm from floor level. The minimum
height is 45 cm if mounting indoors,
and 122 cm if mounting outdoors.
14
• If using rear entry conduit, use at least
one set of the edge mounting holes so
that the conduit does not interfere
with the wall stud.
• If using bottom entry conduit, use the
center two mounting holes.
Note: Ensure that the minimum and
maximum height of the bracket is carefully
selected. It should be installed out of the
way of any reasonably foreseeable
impacts.
2. Attach the bracket using fasteners that
are appropriate for the type of wall
material, drilling pilot holes if necessary.
Use the supplied screws only if mounting
the bracket directly to a wooden stud. If
mounting to another type of wall (hollow,
masonry, etc.), use fasteners that are long
enough to securely anchor the Wall
Connector and can hold at least 36 kg.