Remove The Casing Cover - Kärcher ESB 28 Service Manual

5.2 ESB 34

5.2.1 Remove the casing cover

1 Fastening screw, casing cover

Unscrew the fastening screws of the casing cover.
1 Covering lid
2 Electronics cover
3 Starter (fluorescent lamp)
4 Fluorescent lamp
5 Release, suction stub adjustment
6 Toothed belt, brush roller drive
12
English 5.906-522.0 Rev. 01 (08/11)
5.2.2 Replace fluorescent lamp

Remove the housing cover.
1 Intake, fluorescent lamp
2 Fluorescent lamp

Rotate the fluorescent lamp by 90 degrees and re-
move it toward the front.

Insert the new fluorescent lamp evenly from the
front into both intakes and rotate it by 90°.

Install the casing cover in the reverse order.
5.2.3 Replace the starter

Remove the housing cover.
1 Starter (fluorescent lamp)

Rotate the starter counter-clockwise and remove it
from the intake,.

Insert the new starter into the intake and rotate it
in a clockwise direction until it stops.
The starter must be tightly seated in the intake.

Install the casing cover in the reverse order.