Replace The Motor - Kärcher ESB 28 Service Manual

1 Rubber bearing on the engine

Check correct position of the engine bearing.

Thread in the engine pinion on the toothed wheel
and place the engine into the engine mount.
1 Locking wedge
2 Clamp pocket on engine

Insert the locking wedge into the clamp pocket on
the engine but do not press in yet.

Position the engine mount and tighten the screws.
This will make the locking wedge slide deeper into
the clamp pocket.
14
English 5.906-522.0 Rev. 01 (08/11)

Press the locking wedge down another two notch-
es.

Install the electronics cover as described in the
chapter "Replacing the brush roller".

5.2.6 Replace the motor.


Remove the electronics cover as described in the
chapter "Replacing the brush roller".
1 Motor
2 Engine mount
3 Fastening screws, engine mount

Unscrew the fastening screws of the engine mount
and remove it.