Preface Technical Features Good service work requires extensive and practice- 3.1 ESB 28 oriented training as well as well-structured training Overheat protection of the engine. – materials. Hence we offer regular basic and advanced training 3.2 ESB 34 programmes covering the entire product range for all Overheat protection of the engine with reset key.
Parts of the system 4.1 ESB 28 4.1.1 View from below 1 Rollers 2 Brush roller 3 Running rollers 4 Connection nozzle 5 Suction head plug 6 Nameplate English 5.906-522.0 Rev. 01 (08/11)
Pull the bearing out of the bearing intake on both Using a screwdriver, press in both locking latches sides of the brush roller. on the rear of the ESB 28 and lever them upwards. Remove the toothed belt. 1 Fastening screws, electronics cover...
5.1.3 Replacing the toothed belt 5.1.4 Replace the motor. Remove the housing cover. Remove the electronics cover, as described in the chapter "Replacing the toothed belt". 1 Electronics cover 2 Fastening screws, electronics cover Unscrew the fastening screws of the electronics cover.
5.1.5 Replace connecting cable 5.1.6 Replace PCB Remove the electronics cover, as described in the Remove the electronics cover, as described in the chapter "Replacing the toothed belt". chapter "Replacing the toothed belt". 1 Connecting cable to the vacuum cleaner 1 Connecting cable, engine 2 Fastening screws, traction relief 2 Printed board...
5.2 ESB 34 5.2.1 Remove the casing cover 5.2.2 Replace fluorescent lamp Remove the housing cover. 1 Intake, fluorescent lamp 2 Fluorescent lamp Rotate the fluorescent lamp by 90 degrees and re- move it toward the front. Insert the new fluorescent lamp evenly from the front into both intakes and rotate it by 90°.
Pull the bearing out of the bearing intake on both 5.2.4 Replacing the brush roller sides of the brush roller. Remove the housing cover. Remove the toothed belt. Remove the bearing from the brush roller. Insert the bearing onto the new brush roller.
Press the locking wedge down another two notch- Install the electronics cover as described in the chapter "Replacing the brush roller". 5.2.6 Replace the motor. 1 Rubber bearing on the engine Remove the electronics cover as described in the ...
Page 15
1 Connecting cable, micro switch 1 Cover, cable channel 2 Connecting cable, engine 2 Motor cable Insert the connecting cable into the cable channel. 3 Motor Remove the cover of the cable channel upwards. Remove the engine from the engine intake and thread it out of the toothed belt.
5.2.7 Replace the engine filter Remove the electronics cover as described in the chapter "Replacing the brush roller". 1 LED operating state indicators 2 Printed board Disconnect all connecting cables from the printed circuit board (PCB). 1 Filter fleece ...
Remove the microswitch from the intake toward 5.2.10Replacing the micro switch the top. Remove the electronics cover as described in the Replace the micro switch. chapter "Replacing the brush roller". 1 Printed board 2 Connecting cable, micro switch 1 Connecting cable, micro switch ...
6.2 Cleaning the rollers 7.2 ESB 34 If the rollers of the ESB 28 become difficult to move: The mechanism for protection against overheating switched off the motor when it is overloaded, for e.g. because the brush roller is blocked.