Kärcher ESB 28 Service Manual page 15

1 Cover, cable channel
2 Motor cable
3 Motor

Remove the cover of the cable channel upwards.

Remove the engine from the engine intake and
thread it out of the toothed belt.
1 Printed board
2 Connecting cable, engine

Disconnect the connecting cable of the engine
from the printed circuit board (PCB).

Replace the engine.
1 Connecting cable, micro switch
2 Connecting cable, engine

Insert the connecting cable into the cable channel.
1 Cover, cable channel

Replace the cover and close the cable channel.

Install the new engine as described in the chapter
"Replacing the toothed belt".
English 5.906-522.0 Rev. 01 (08/11)
15