Call Timeout Options - Teo 7810 TSG Series Installation Instructions Manual

Teo IP Phone 7810 TSG Series Installation Instructions
C a l l T i m e o u t O p t
C a l l T i m e o u t O p t
These options set dialing, ringing, and reorder timeouts.
From the Installation Options menu, select CALL.
→ INSTL → ► → CALL)
(
SETUP
D i a l i n g T i m e o u t
D i a l i n g T i m e o u t
Select DIAL.
Enter the number of seconds (1-30) to wait after entering digits, before a call is
automatically dialed without selecting SEND or pressing the
select CLEAR for no dialing timeout (automatic dialing after timeout is disabled).
R i n g i n g T i m e o u t
R i n g i n g T i m e o u t
Select RING.
Enter the number of seconds (1-300) that an incoming call will ring, before ringing
is turned off and the call is abandoned. Enter 0 or select CLEAR for no ringing
timeout (call continues to ring).
R e o r d e r T i m e o u t
R e o r d e r T i m e o u t
Select REORDER.
Enter the number of seconds (1-300) that the phone will remain in a disconnected
or error state before the call is cleared. Enter 0 or select CLEAR for no reorder
timeout (call remains in a disconnected or error state).
Page 50
i o n s
i o n s

CALL TIMEOUT OPTIONS

DIAL RING REORDER
DIALING TIMEOUT SEC=10
DELETE CLEAR 123
RINGING TIMEOUT SEC=180
DELETE CLEAR 123
REORDER TIMEOUT SEC=180
DELETE CLEAR 123
key. Enter 0 or
OK
13-280138 Rev. H