Configuring Keys - Teo 7810 TSG Series Installation Instructions Manual

Teo IP Phone 7810 TSG Series Installation Instructions
C o n f i g u r i n g K e y s
C o n f i g u r i n g K e y s
You can assign line appearances, feature activators, and DSS/BLF/Speed Dial numbers to
keys, and set up the VOICE MAIL
From the Installation Options menu, select KEYS.
→ INSTL → KEYS)
(
SETUP
The status indicator for each key will indicate the current setting:
Green
Red
Off
On the phone or 8030X Button Expansion Module, press the line or multifunction
key to be programmed.
The selected key's indicator will alternately flash red and green.
Select LINE (Line Appearance), FA (Feature Activator), DSS (Direct Station
Select/Busy Lamp Field), SPDIAL (Speed Dial), ACD (Automatic Call Distribution), or
UNUSED from the menu.
Programming procedures for each key type are described below.
When finished editing keys, press the
menu or press the
K e y L a b e l s
K e y L a b e l s
The line and multifunction keys on the phone are labeled on the display. You can
customize the labels for Line Appearance, Speed Dial, and DSS/BLF keys by entering user
names or other identifiers.
Paper labels are used on the 8030X Button Expansion Module. 8030X label templates for
Microsoft Word can be downloaded from
After selecting a multifunction key, the key type, and the EDIT menu selection,
press the Left or Right Arrow key repeatedly until LABEL is shown in the menu.
Page 36
and SPKR keys by using this option.
– Line Appearance or DSS/BLF
– Feature Activator
– Unused or Speed Dial
SELECT A KEY
12=UNUSED
LINE FA
12=UNUSED
ACD UNUSED
OK
SETUP key to exit Setup Mode.
www.teotech.com
LINE KEY OPTIONS
ADD REMOVE LABEL
¤
DSS SPDIAL
£
key to return to the Installation Options
.
¤
13-280138 Rev. H