Canopy Assembly; Blade Assembly - Ellington E-LAV52BP4LK Installation Manual

8. Canopy Assembly.

Temporarily raise canopy to hanging bracket to
determine which screws in hanging bracket align
with slotted holes in canopy, and then lower canopy
and partially loosen these 2 screws. Remove the other
2 screws and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws and secure all screws with Phillips
screwdriver.

9. Blade Assembly.

Time Saver: Washers for blade screws can be
set on each blade screw prior to installing
blades.
Locate 12 blade attachment screws and
washers in hardware pack. Slide blade through
one of the narrow, rectangular openings on
motor housing, aligning holes in blade with
holes in blade arm (located on the underside
of the motor housing)--refer to drawing at right.
Insert 3 blade attachment screws (along with
washers) with fingers first and then tighten
screws securely with a Phillips screwdriver.
Repeat procedure for each remaining blade.
Note: Tighten blade arm screws twice a year.
blade
blade
arm
page 7
hanging bracket
canopy
blade attachment
screws and washers
motor housing
(underside)