Automated Learning Process./Activating Code; Wall Control Operation - Ellington E-DER54ESP5CR Installation Manual

11. Automated Learning Process./Activating Code.

CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is
not desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set
the code switches 1 through 4 for the
transmitter. Use the same number sequence used
when wiring the wall control in Section 6.
Locate dimmer switch to the right of the code
switches labeled with a "D" and an "X". Set
dimmer switch to the ON (D) position only if
using incandescent bulbs. Set dimmer to OFF (X)
position if using compact fluorescent (CFL) bulbs.
NOTE: Most compact fluorescent bulbs are not
compatible for use with dimmer control.
Install one 9-volt battery (sold separately) in
transmitter. Note: Leave battery connected but
outside of battery compartment until learning
process is complete.
Restore electrical power and then set slider
switch on wall control to the ON position. Within
30 seconds of turning on the wall control, press
the "OFF" button, located on the front of the
transmitter, for 5 seconds or until light blinks
twice. Test the light and fan functions to confirm
the learning process is complete--see Section 14.
Place battery in battery compartment and then
re-attach battery cover on transmitter.

12. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN OFF button - turns fan OFF
U/L button - turns upper light ON/OFF when pressed once;
dims upper light when pressed and held down
D/L button - (for use with optional light kit--sold
separately) turns lower light ON/OFF when pressed once;
dims lower light when pressed and held down
REV button - used to REVERSE blade direction (fan must be
set on low before reversing blade direction)
TRANSMITTER
dimmer
switch
TRANSMITTER
page 9
code
(back)
switches
battery
cover
(front)