Automated Learning Process./Activating Code; Wall Control Operation - Ellington LS52ABZ5CRGD Installation Manual

10. Automated Learning Process./Activating Code.

CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other programmable
receiver or fan.
This remote control transmitter is equipped with 16 code
combinations to prevent possible interference from or to
other remote units such as garage door openers, car
alarms or security systems. If you find that your fan and
light go on and off without using your remote control,
simply change the combination code in your remote
control transmitter (and wall control). To set the code,
perform these steps:
Remove battery cover from back side of transmitter.
Use a ballpoint pen or a small screwdriver to set the code
switches 1 through 4 for the transmitter. Use the same
number sequence used when wiring the wall control in
page 6, Section 6.
Locate dimmer switch (labeled D and X) to the right of
the code switches. Dimmer switch has been pre-set to the
"OFF" position (X). [Note: Most compact fluorescent
bulbs, including the ones provided with this fan, are not
compatible for use with dimmer controls.]
Install 9-volt battery (sold separately) in transmitter and
then re-attach the battery cover.
IMPORTANT: Store the transmitter away from excess heat
or humidity. To prevent damage to transmitter, remove
the battery if not used for long periods.
Restore electrical power and then set slider switch on wall
control to the ON position. Within 30 seconds of turning
on the wall control, press and hold the FAN/OFF button
on the front of the transmitter for 5 seconds or until lower
light blinks twice. Test the fan and light functions to
confirm the learning process is complete--see Section 13.

11. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF
HI button - turns fan to HIGH speed
MED button - turns fan to MEDIUM speed
LOW button - turns fan to LOW speed
FAN OFF button - turns fan OFF
D/L button - turns lower light ON/OFF when pressed
once
U/L button - turns upper light ON/OFF when pressed
once; dims upper light when pressed and held down
dimmer
switch
page 8
TRANSMITTER
(back)
battery
cover
TRANSMITTER
(front)
dip
switches