Automated Learning Process./Activating Code - Ellington ART52OB5 Installation Manual

10. Automated Learning Process./Activating Code.

5
Remove battery cover on back side of remote control transmitter.
Install 12-volt battery (provided) in transmitter.
IMPORTANT: Store the transmitter away from excess heat or humidity. To prevent damage to transmitter,
remove the battery if not used for long periods.
Fan SPEED control buttons1:
Fan OFF button 2:
REVERSE function button 3:
LIGHTING button 4:
CODE SWITCHES and SET button 5: With fan power off, arrange CODE SWITCHES to desired code
DIMMING function 6:
Replace the battery cover on transmitter.
remote control
2
III IV
II V
1
I VI
3
4
6 5
ON ECE
SET
1 2 3 4
12V
BACK
Use to control the ceiling fan speed 1-6
Use to turn the fan off
Use to control fan direction
Use to control down-light and up-light (if applicable)
setting. Restore electrical power, press and hold SET button on
back of remote control for 5 seconds within 60 seconds of
powering fan in order to synchronize with fan motor.
Dimming capability is determined by the type of bulbs provided
with the fan. If no bulbs are provided, dimming function will
not work.
OFF position = D On position = ON
page 9