Photon Focus D/L-2048 User Manual page 22

Cmos camera with gige interface

Table of Contents

3 How to get started (GigE G2)

Select a valid IP address for selected camera (see Fig. 3.12). There should be no

exclamation mark on the right side of the IP address. Click on Ok in the Set IP Address

dialog. Select the camera in the GEV Device Selection dialog and click on Ok.

Figure 3.12: Setting IP address

Finish the conﬁguration process and connect the camera to PF_GEVPlayer .

Figure 3.13: PF_GEVPlayer is readily conﬁgured

The camera is now connected to the PF_GEVPlayer. Click on the Play button to grab

images.

An additional check box DR1 appears for DR1 cameras. The camera is in dou-

ble rate mode if this check box is checked. The demodulation is done in the

PF_GEVPlayer software. If the check box is not checked, then the camera out-

puts an unmodulated image and the frame rate will be lower than in double

rate mode.

Table of Contents