Installing A Child Seat With A Lap/Shoulder Seat Belt; Adding Security With A Tether - Honda ODYSSEY 2020 Owner's Manual

SAFETY INFORMATION

Installing a Child Seat with a Lap/Shoulder Seat Belt

n
A child seat can be installed with a lap/shoulder belt in any rear seat or, if
absolutely necessary, the front passenger seat.
1. Place the child seat on the vehicle
seat.
2. Route the seat belt through the child
seat according to the seat
manufacturer's instructions, and
insert the latch plate into the buckle.
Insert the latch plate fully until it
clicks.
3. Slowly pull the shoulder part of the
belt all the way out until it stops.
This activates the lockable
retractor.
4. Let the seat belt retract a few
inches and check that the retractor
has switched modes by pulling on
the webbing. It should not pull out
again until it is reset by removing
the latch plate from the buckle. If
you are able to pull the shoulder belt
out, the lockable retractor is not activated. Slowly pull the seat belt all
the way out, and repeat steps 3 – 4.
5. Grab the shoulder part of the seat
belt near the buckle, and pull up to
remove any slack from the lap part
of the belt. When doing this, place
your weight on the child seat and
push it into the vehicle seat.
24 |
6. Make sure the child seat is firmly
secured by rocking it forward and
back, and side to side; less than one
inch of movement should occur
near the seat belt.
7. Make sure any unused seat belt that
a child can reach is buckled. The
lockable retractor is activated and
the seat belt fully retracted and
locked.
To deactivate a lockable retractor, release the buckle and allow the seat
belt to wind up all the way.

Adding Security with a Tether

n
A tether anchorage point is provided behind each second and third row
seating position. If you have a child restraint system that comes with a
tether, but can be installed with a seat belt, the tether may be used for
additional security. Always use a tether for forward facing child seats when
using the seat belt or lower anchors.
1. Locate the appropriate tether anchorage point.
SAFETY INFORMATION
| 25