Turning The Handset On/Off - Alcatel SP-R5200 Operations & Installation Manual

Table of Contents

2-7 Turning the Handset On/Off

When you place the handset in the base unit to charge it, the handset automatically turns on. To turn the

handset on or off in Standby mode, follow these steps:

1. To turn on the handset when the display is off, press

Result: All segments in the LCD window turn on briefly, then the phone switches to the Standby mode. The

phone is now ready for use. The display shows the handset number and the base number as shown

below.

2. To turn the handset off, press and hold

display.

Result:

appears, then the display turns off.

Notes:

¥ If you purchase an additional handset, you must register the handset to a base. If not, the display

shows

when you turn it on and the handset will not work. Refer to ÔRegister New Handset with

BaseÕ on page 2-33.

¥ Nothing will appear in the LCD window when battery power is very low. You should fully charge the

handset before operation.

2-9

Handset number

button for about three seconds until

button.

Base number

appears in the

Operations & Installation

Table of Contents

Do you have a question about the SP-R5200 and is the answer not in the manual?