Assembly Instructions; Attaching And Removing The Blower/Vac Tube - Yardworks 60-3856-2 Owner's Manual

ATTACHING AND REMOVING THE
BLOWER/VAC TUBE
WARNING:
injury, the Blower/Vac tube and the vacuum bag
must be used when operating this Blower/Vac.
Attaching the Blower/Vac tube
NOTE: The blower/vacuum tube comes disassembled
from the Blower/Vac. It must be installed in order
to ensure safe and easy operation.
WARNING:
injury, verify that the power switch is in the OFF
position, that the Blower/Vac is unplugged, and
that the impellers have stopped before attach-
ing or removing the tubes.
remove the screws and nuts that are pre-installed on
1.
the Blower/Vac housing (Fig. 1).
2. Insert the Blower/Vac tube all the way into the opening
on the motor housing, until the holes in the tabs on the
Blower/Vac tube align with the screw holes in the
housing (Fig. 1).
Insert the 2 M 5x20 screws into the right side of the
3.
motor housing, and insert the 2 nuts into the
left side of the motor housing (Fig. 1).
Screw
4. Tighten the screws securely. Do not overtighten.

ASSEMBLY INSTRUCTIONS

In order to avoid serious personal
In order to avoid serious personal
Motor Housing
Nut
Blower/Vac
Fig. 1
Removing the Blower/Vac tube
NOTE: It may be necessary to remove the Blower/Vac tube
in order to clear a blocked tube or impeller.
1. Remove the 2 screws and nuts that are holding the
Blower/Vac tube onto the housing (Fig. 2).
NOTE: Keep the hardware in a safe place for future use.
Screw
and Nut
Tube
2.
Remove the Blower/Vac tube from the motor housing.
3. Re-attach the Blower/Vac tube before using the
Blower/Vac.
8
WARNING: In order to avoid serious personal
injury, verify that the power switch is in the OFF
position, that the Blower/Vac is unplugged, and
that the impellers have stopped before attaching
or removing the tubes.
Screw and Nut
Fig. 2