Table of Contents
Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten unless instructed.
Some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, they must be wrench tighten to fully go on.
1A. Attach Frame A (A) to Weight Stack Frame (WM) using:
4 - (#8) M12X35mm Hex Head Bolt
8 - (#51) 13mmX24mm Flat Washer
4 - (#41) M12 Nylon Lock Nut
1B. Attach Bracket (WT) to Weight Stack Frame (WM) using:
2 - (#51) 13mmX24mm Flat Washer
2 - (#41) M12 Nylon Lock Nut
22
Advertisement
Table of Contents
