Advertisement
FADE-In = On ... when the CLP2600 is turned on all Outputs not previously muted before the
Unit was switched off will be active, meaning the CLP2600 outputs will be controlled by a
volume ramp to avoid any sudden sound.
If the option
Fade-In=On
Delay Time/Distance: this page allows you to select the measurement unit to be used for
the Delays: Time (in milliseconds "ms") or Distance (in meters
By pressing ENTER and rotating the
measurement unit to be used for the delay, which will be confirmed by pushing the ENTER
button.
The following screen shows the selected delay measurement is Time (milliseconds)
Input Routing: the CLP2600 Processor is equipped with 2 Analog Inputs (Balanced Female
XLR) and a stereo S/PDIF Digital Input (RCA connector).
The
Routing Options
By pressing ENTER on Input Routing and then rotating the
possible to select the Main Inputs for the CLP2600, allowing the User to choose between
Analog or S/PDIF Digital.
The selection can be confirmed by pressing the
The following screen shows that the Analog Input has been selected:
Software Version: this page allows you to confirm the Software Version running on the
CLP2600:
The correct Software Version is
is selected, the screen will show the following:
Power-On Procedure
Fade-In: On
SYSTEM UTILITY:
Delay Units
PM2
Delay Units
Unit : Time (ms)
page allows you to select the desired Input type:
SYSTEM UTILITY:
Input Routing
Input Routing
Source: Analog
SYSTEM UTILITY:
Software Version
V1.00
or
PM3
encoder, it is possible to select the
ENTER
button.
10
m ) :
PM2
or
PM3
encoder, it is
Advertisement
