Advertisement
The CLP2600 multi band compressor, can operate as 3 bands, 2 bands or Mono band compressor
unit.
Because of that, within the Compressors Menu there are up to 3 common control pages, allowing
the user to set the number of bands for the compressor and, dependently from this selection, to
set the X-Over frequencies for the definition of the 3 or 2 bands...if not set in Mono band mode.
The setting of anyone of these common control is replicated on each editing Menu of each of the
active bands...independently from where (within what band's editing Menu...) the controls have
been set.
When the CLP2600 is set as 3 bands compressor, each single band compressor can be accessed
for an independent editing session, just entering each one of the 3 compressors' editing pages,
Lim/Comp - Edit/Bypass
pressing the
row at the left side of the LCOMP/RCOMP labels.
If the CLP2600 is set for a number of bands minor than 3, then accordingly with the bands
number, only the first or second button will allow the access to the single or to the 2 bands.
The buttons order is set so to be the number one the button locate at the most far left position
from the LCOMP/RCOMP labels.
Band Mode page
bands process by an independent RMS compressor .
To set the Band Mode press ENTER an arrow will appear on the left of the screen
encoder to set thedesired number of Bands .
the PM3
If selected 3, the CLP2600 will work as 3 bands stereo compressor and the all three bands will be
processed by an independent RMS compressor which parameters can be edited by 3 different
Menu accessed through the Lim/Comp – Edit/Bypass
LCOMP/RCOMP led bars.
If selected 2, the number of bands will be 2, and the editing menu closer to the LCOMP/RCOMP
labels will be not accessible.
If selected 1, the CLP2600 will be a powerful MONO BAND compressor, the only accessible Editing
Menu for setting the RMS compressor parameters will be the one accessed by the buttons
Lim/Comp
Edit/Bypass
most far left position from the LCOMP/RCOMP labels .
The following is an example screen for the
from this page it is possible to set CLP2600 way of working in terms of sub-
buttons at the bottom of the LCOMP/RCOMP led bars located at the
OutputA Left
-> Band Mode = 3 Band
button set at the bottom of the first, second and third led
buttons at the bottom of the
Band Mode
page where the Band Mode is set as 3:
Cmp
29
->
. then use
Advertisement
