Advertisement
●
Menu
RMS Compressors
Edit/Bypass
Default Screen , it is possible to access the
From the
Lim/Comp - Edit/Bypass
pressed, the related blue
The Sub-Menus pages can now be scrolled through by rotating clockwise and counter-clockwise
the
NAV/PM1
encoder.
For parameter editing it is necessary to press ENTER and an arrow will appear on the left of the
->
. Then use the
screen
values. On some parameters that have three independent values, you will also need to use the
NAV/PM1 encoder, for example for the filter s parameter setting.
The "Lim/Comp - Edit/Bypass" buttons have also the RMS COMPRESSOR BYPASS function: if
pressed for more than 3 seconds, the RMS COMPRESSOR of the related Channel will be BYPASSED
and the LED will turn RED.
To ACTIVATE again the RMS COMPRESSOR it is enough from the BYPASSED condition to press
again the "Lim/Comp - Edit/Bypass" button for more than 3 seconds.
Note: All parameter editing can be done using the
the current shown value of the selected option is AUTOMATICALLY loaded during the encoders'
use and stored as the current value once leaving the page.
RMS Compressors (LCOMP/ RCOMP) Block Scheme
The CLP2600 processing core is based on 3 powerful RMS compressors on each channel, that can
be applied to 3 sub bands definable by the user.
The CLP2600 is by the way very flexible allowing to eventually set the compression process as a 2
bands or even Mono band one.
On its input path, then, after the AGC and Eq, and before the final Peak Limiter, the CLP2600
make available to the user a powerful "up to 3 band
independently on each one of its 3 RMS
2 of them (if set the 2 bands Mode) or even just one (when in Mono band mode).
In addition, a control for setting the Compressor Mode (2/3 or Mono band) so as, when set in
multi band, a control for setting the Cross bands frequencies.
In the following block scheme, showing the CLP2600 overall structure, the RMS Compressor
section is represented by the purple not shaded block.
buttons]
button s at the bottom of the 3xLCOMP or 3xRCOMP led bars . Once
EDIT
LED will turn ON.
PM2
and
Sub
Editing [access by pushing the
RMS Compressors
PM3
encoders for selecting and setting the parameter
NAV/PM1 ,
RMS Compressor, which is editable
Compressors (if set the 3 bands mode) or even just
28
Lim/Comp -
menu by pressing the
PM2 , and
PM3
encoders and
Advertisement
