Advertisement
MENU LCOMP/RCOMP
This Menu is related to the editing of the RMS compressors parameters and to the selection of the number of bands for the CLP2600 compressor to
work with.
The CLP2600 can work as Monoband or 2/3 bands stereo compressor.
If the CLP2600 has been set as Monoband compressor, no choice is allowed for the X-Over frequencies used for the band division in Multi band
mode, and ONLY the FIRST of the 3 available compressor is editable.
If the CLP2600 has been set as 2 bands compressor, the user can set the X-Over frequency used for the 2 bands creation and ONLY the FIRST and
SECOND of the 3 available compressors are editable.
If the CLP2600 has been set as 3 bands compressor, the user can set the X-Over frequencies used for the 3 bands creation and ALL the the 3
available compressors are independently editable.
The selection of the Compressor type and the eventual X-Over frequencies can be done from anyone of the compressors' editable pages and it is
linked to the all other 2 compressors editing pages.
So, if selected the number of bands in the editing environment of the Compressor 1, the choice will be replicated on the editing environments of
the Compressors 2/3.
So, if selected the Monoband Compressor from the editing environment of the Compressor 3, the environment will be no longer accessible in the all
compressor's parameters and to edit the Monoband compressor will be necessary to access the editing environment/pages of the Compressor 1.
NAV/PM1 Encoder
[to navigate between menus]
1. Output[A/B][ Left/Right]
Band Mode = 3
ESC
ENTER
-> Band Mode = 3
If selected 1 as Band Mode in the previous page, then skip to point 4.
2. Output[A/B][ Left/Right]
180Hz
ESC
ENTER
-> 180Hz
If selected 2 as Band Mode in the previous page, then skip to point 4.
3. Output[A/B][ Left/Right]
800Hz
ESC
ENTER
-> 800Hz
4. Output[A/B][ Left/Right]
Attack Time = 5ms
ESC
ENTER
-> Attack Time = 5ms
5. Output[A/B][ Left/Right]
Release Time = 1. 1s
ESC
ENTER
-> Release Time = 1.1s
RMS Compressors Editing [Access by pushing the
Cmp
CrossOver1
CrossOver2
Cmp1
Cmp1
NAV/PM1 Enc .
[to chose values for the parameters, no need to confirm the chosen values,
which are automatically loaded during the encoders use]
PM1 N/A
PM1 N/A
[If in 2 bands mode]
[If in 3 bands mode]
CrossOver2 Freq.
PM1 N/A
PM1 N/A
PM1 N/A
7
Lim/Comp - Edit/Bypass
PM2 Enc.
PM3 Enc.
PM2 N/A
20Hz
PM3 N/A
:
20kHz
CrossOver2 Freq.
PM3 N/A
:
20kHz
PM2 N/A
200ms
PM2 N/A
buttons]
1
:
3
5ms
:
0.1s
:
3.0s
Advertisement
