Advertisement
MENU
Input LIN/RIN
NAV/PM1 Encoder
[to navigate between menus]
1. Output [A/B][ Left/Right]
20.0 Hz
No Cut-Off
ESC
ENTER
-> 20.0 Hz
No Cut-Off
2. Output [A/B][ Left/Right]
20.0 Hz
No Cut-Off
ESC
ENTER
-> 20.0 Hz
No Cut-Off
Output [A/B][ Left/Right]
3.
BW/SHV_Slope=1.00/up to -12dB
1.00kHz
ESC
ENTER
If through the PM2, being the filter's gain = 0.0dB,
has been selected a
Bell
BW to be greater then 0, then the Bell filters can be set by
the following parameters
3.1 Output [A/B][ Left/Right]
-> 1.00kHz BW=1.00 +0.0dB
If through the PM2, being the filter's gain = 0.0dB,
has been selected a
Low Shelving filter
st
nd
order available, -6dB or -12dB), then the
Slope (1
or 2
Low Shelving filter can be set by the following parameters
3.2 Output [A/B][ Left/Right]
-> 1.00kHz (-6/-12)LoSh +0.0dB
If through the PM2, being the filter's gain = 0.0dB,
has been selected a
High Shelving filter
st
nd
order available, -6dB or -12dB), then the
Slope (1
or 2
High Shelving filter can be set by the following parameters
3.3 Output [A/B][ Left/Right]
-> 1.00kHz (-6/-12)HiSh +0.0dB
Input Channels Editing [Access by pushing the
HPF
LPF
EQ - 1/ 5
+ 0.0dB
filter, just defining its Bandwidth
EQ-X (up to 5 filters available)
, just defining its
EQ-X (up to 5 filters available)
, just defining its
EQ-X (up to 5 filters available)
NAV/PM1 Enc .
[to chose values for the parameters, no need to confirm the chosen values,
which are automatically loaded during the encoders use]
PM1 N/A
PM1 N/A
(when the filter's gain = 0.0dB ONLY, through the PM2 it is possible to
chose and select between a Bell or a Shelving filter)
[Freq.]
20Hz
:
20kHz
[Freq.]
20Hz
:
20kHz
[Freq.]
20Hz
:
20kHz
4
EQ Edit/Mute
buttons]
PM2 Enc.
PM3 Enc.
[Freq.]
[Type/Slope] No Cut-Off
20Hz
:
20kHz
[Freq.]
[Type/Slope] No Cut-Off
20Hz
:
20kHz
[BW] 0.05
[Amp.]
:
3.00
[Amp.]
PM2 N/A
[Amp.]
PM2 N/A
:
Bessel 24dB/Oct
:
Bessel 24dB/Oct
-15.0 dB
:
+15.0 dB
-15.0 dB
:
+15.0 dB
-15.0 dB
:
+15.0 dB
Advertisement
