Advertisement
CrossOver 1 page
and the RMS single compressor will act on the overall input band.
When the CLP2600 is set as
Cross Over frequency separating the 2 bands dividing the full one .
On each of the 2 bands, below and above the selected frequency, 2 independent RMS
compressors will act.
When the CLP2600 is set as
Cross Over frequency separating the 2 lower bands of the 3 dividing the full one .
On each of the 3 bands, 3 independent RMS compressors will act.
To set the
band 1
will appear on the left of the screen
of bands.
The range of the selectable frequencies is going from 20Hz up to 20kHz by steps of 1/12 of
octave.
Has to be taken carefully in account by the user that when selected the
CrossOver 1 selected frequency is not overlapping the one selected on the CrossOver 2 editing
page.
The following is an example screen for the
set to 250Hz:
CrossOver 2 page
page is not available and the RMS single compressor (1 band mode selection) or the 2 RMS
compressors (2 band mode selection) will act on the overall or on the 2 selected input bands.
When the CLP2600 is set as
Cross Over frequency separating the 2 higher bands of the 3 dividing the full one .
On each of the 3 bands, 3 independent RMS compressors will act.
To set the
band 2
will appear on the left of the screen
of bands.
The range of the selectable frequencies is going from 20Hz up to 20kHz by steps of 1/12 of
octave.
Has to be taken carefully in account by the user that when selected the
CrossOver 2 selected frequency is not overlapping the one selected on the CrossOver 1 editing
page.
The following is an example screen for the
set to 2500Hz:
when the CLP2600 is set in Mono Mode,
2 band
3 band
(Low) and the
band 2
->
OutputA Left
->
when the CLP2600 is set in Mono Mode,
3 band
(Mid) and the band 3
->
OutputA Left
->
compressor, then from this page it is possible to set the
compressor, then from this page it is possible to set the
(High) Cross Over Frequency press ENTER an arrow
. then use the PM2
CrossOver 1
page where the Cross Over frequency is
CrossOver 1
250 Hz
compressor, then from this page it is possible to set the
(High) Cross Over Frequency press ENTER an arrow
. then use the PM2
CrossOver 2
page where the Cross Over frequency is
CrossOver 2
2500 Hz
30
1 band , this page is not available
encoder to set the desired number
3 band
1 band , or in
2 band
encoder to set the desired number
3 band
th
mode, the
Mode, this
th
mode, the
Advertisement
