Advertisement
Delay page – from this page it is possible to set the Output Channels Delay Time from
000.0000mS up to 848.9984mS, by steps of 1mS or 20.8uS.
To set the Delay time press ENTER an arrow will appear on the left of the screen
the
PM2
encoder to set the Delay Time in steps of 1mS and the
Delay Time in steps of 20.8 microseconds.
The following is an example screen for the
1 is set to 160.1872mS:
Polarity page
from this page it is possible to set the Output Channels Polarity, by using the
PM3
encoder.
The polarity can be
The following is an example of a
Normal
Peak Limiter sub-menu – from this page it is possible to set the Output Channels Peak Limiter.
The following is an example screen for the Peak Limiter page where the Attack Time of the
Limiter is set at 5ms, the Release Time is set at 0.2Sec and the
set at + 15dB:
Once pushing ENTER the Peak Limiter's parameters can be modified using the
encoders for editing the Peak Limiter's Attack Time [A]., Release Time [R] and Active
and
PM3
Threshold.
Once pushing ENTER the above screen will change as follows:
The Attack Time [A] can be edited using the NAV/PM1
encoder and the Peak Limiter Active Threshold the
OutputA Left
-> Delay = 160.1872mS
Normal
or
Inverted
Polarity
OutputA Left
-> Polarity = Normal
OutputA Left
A: 5ms
OutputA Left
-> A: 5ms
Delay
page where the Delay Time of Output Channel
Delay
(which means rotated of 180 Degrees).
screen where the Polarity of Output Channel 1 is set to
Polarity
Limiter
R: 0.2s +15.0dB
Limiter
R: 0.2s +15.0dB
encoder, the Release Time [R] the PM2
PM3
encoder.
26
->
PM3 , for setting the
Peak Limiter Active Threshold is
NAV/PM1 ,
. then use
fine
Peak
PM2
Advertisement
