Configuring An E1 Channel - HP HSR6800 Configuration Manual

Step
8. Configure the SOH and
higher-order path overhead
bytes
9. Set the physical state change
suppression interval on the
interface.
10. Set the intended bandwidth
for the CPOS interface.
11. Restore the default settings for
the CPOS interface.
12. Shut down the CPOS
interface.
13. Set the signal degrade (SD) or
signal fail (SF) alarm threshold
for the interface.
14. Configure E1/T1/E3/T3
channel attributes.

Configuring an E1 channel

Step
1. Enter system view.
2. Enter CPOS interface view.
3. Set the framing format for E1.
4. Set the clock mode for E1.
5. Set the loopback mode for E1.
Command
flag { c2 path-number c2-value | s1
s1-value | s1s0 path-number
s1s0-value }
flag { j0 | j1 path-number } { sdh |
sonet } flag-value
link-delay seconds
bandwidth bandwidth-value
default
shutdown
threshold { sd | sf } value
•
See "Configuring an E1
channel."
•
See "Configuring a T1
channel."
•
See "Configuring an E3
channel."
•
See "Configuring a T3
channel."
Command
system-view
controller cpos cpos-number
e1 e1-number set frame-format
{ crc4 | no-crc4 }
e1 e1-number set clock { master |
slave }
e1 e1-number set loopback { local
| payload | remote }
60
Remarks
Optional.
Optional.
By default, physical state change
suppression interval is disabled on
the interface.
Optional.
Optional.
Optional.
Up by default.
Optional.
By default, the SD alarm threshold
is 10e-6 (the value argument is 6),
and the SF alarm threshold is
10e-3 (the value argument is 3).
Optional.
Remarks
N/A
N/A
Optional.
no-CRC4 by default.
Optional.
Slave by default.
Optional.
Disabled by default.