Configuring The Working Mode Of A Pos Interface Card; Displaying And Maintaining Pos Interfaces; Pos Interface Configuration Example; Directly Connecting Routers Through Pos Interfaces - HP HSR6800 Configuration Manual

Configuring the working mode of a POS interface
card
Some POS interface cards support multiple working modes. You can switch their working modes as
needed. For more information about the working modes of interface cards, see Fundamentals
Configuration Guide.

Displaying and maintaining POS interfaces

Task
Display information about one or
all POS interfaces.
Clear statistics of one or all POS
interfaces.

POS interface configuration example

Directly connecting routers through POS interfaces

Network requirements
As shown in
to connect the POS interfaces on Router A and Router B.
Encapsulate the interfaces with PPP.
Figure 4 Network diagram
Configuration procedure
1. Configure Router A:
# Configure interface POS 2/1/0, setting its physical parameters to defaults.
<RouterA> system-view
[RouterA] interface pos 2/1/0
[RouterA-Pos2/1/0] ip address 10.110.1.10 255.255.255.0
[RouterA-Pos2/1/0] link-protocol ppp
[RouterA-Pos2/1/0] mtu 1500
[RouterA-Pos2/1/0] shutdown
Figure 4, use a pair of single mode optic fibers (for receiving and sending data, respectively)
Command
display interface [ pos ] [ brief [ down ] ] [ |
{ begin | exclude | include }
regular-expression ]
display interface pos interface-number
[ brief ] [ | { begin | exclude | include }
regular-expression ]
reset counters interface [ pos
[ interface-number ] ]
50
Remarks
Available in any view.
Available in user view.