Machine Start Up - JEI MAGBEAST 2 Safety Instructions And Operator's Manual

JEI SOLUTIONS LTD

2. Machine start up

The machine is supplied in a metal box with complete standard equipment.
MAGBEAST 2 comes in a standard equipment set which consists of:
2.1 Before first drill:

Steel elements of the drilling machine are protected for transit and storing with grease
film. Before first start up of the machine all grease should be removed

Before each use all handles should be screwed into pinion.
2.2 Before you cut
Before positioning the machine on work piece always make sure that:
Work piece is made of ferromagnetic steel (some grades of stainless or acid
-
resistant steel does not conduct magnetic flux)
thickness of work piece is at least 3/8" (10 mm)
-
surface of steel under the magnet is flat
-
wipe, brush or sand down clean surface where you intended to place the drilling
-
machine, so that you remove rust, paint, dirt etc which would reduce adhesive power of the
electromagnetic base.
Install drill bit, milling cutter or other tooling such as tap or reamer in the machine before
plugging it into mains. Then plug it in (see paragraph 2) and position where you wish to use
it. Place the machine so that the tool is over the centre of the hole you intend to make and
turn the magnetic base ON.
Prior to use always make sure that the machine is secured from falling
down with original chain (as described in paragraph I no.2 "Important rules of

metal box

drilling machine

arbor AMT2-C-19/2-2

cooling system

chip guard

spoke handles

hex wrench s=4

hex wrench s=5

wedge, MT2

safety chain with snap hook

operator's manual
safe use of drilling machine").
Operator's manual for Drilling Machine MAGBEAST 2
MAGBEAST 2
1pc
1pc
1pc
1pc
1pc
3pcs
1pc
1pc
1pc
1pc
1pc
- 8 -