Operating Instructions; Adjustment, Maintenance And Service - JEI MAGBEAST 2 Safety Instructions And Operator's Manual

JEI SOLUTIONS LTD
3.

Operating instructions

The machine is supplied in a metal box. Steel elements of the drilling machine are
protected for transit and storing with grease film. Before first start up of the machine all
grease should be removed. Before each use all spoke handles should be screwed into
pinion.
Control panel includes below elements:
 (01) - Main switch MAGNET,
 (02) - START-STOP switch MOTOR.
a) In order to start the machine press the main switch MAGNET (01) on "I" button. Now you
can start the motor by pressing green button MOTOR (02) on "I".
b) Stopping the motor is executed with red button „O" (then the motor is switched
OFF but the electromagnetic base is still ON) (02).
c) To move machine into next drilling spot, stop the motor as described above and
push the mains switch (01) to the position "O".
d) To change the speed use the gear box lever.
To move machine into next drilling spot, stop the motor as described above and
push the mains switch MAGNET to the position "O". To change the speed use the
.
READ THE WHOLE INSTRUCTIONS MANUAL
III. ADJUSTMENT, MAINTENANCE AND SERVICE

Every 50 hours of work, or as need arises, elimination of excess play in slide guides
should be performed. The screws are provided for that reason. Play in slide guides is
acceptable the slide goes up easily and does not slide down under its own weight. (see
paragraph II no.2.8)

After every day's work position of gear lever (used for selection of gearbox speed) should
be changed. For example if machine ran at 150 rpm speed, it should be switched to
300rpm.
 Regularly check condition of carbon brushes. (see paragraph IV – Technical data).

Regularly lubricate brass slide guide inserts with grease as well as the rack and pinion.

To prevent the machine from rusting (especially when used outdoors) all steel parts
should be covered with thin layer of grease film.

Damaged machine parts to be exchanged only to original parts.
gear box lever.
BEFORE ATTEMPTING TO START UP
Operator's manual for Drilling Machine MAGBEAST 2
MAGBEAST 2
- 15 -