Table of Contents
Advertisement
JEI SOLUTIONS LTD
2. GENERAL SAFETY ADVICE
Drilling machine must not be used when:
The operator has not read the Operator's Manual.
1.
2. The work to be done is not in agreement with the recommendations in this Manual.
3. Drilling machine is not complete or has been repaired with non-original parts.
4. Power supply parameters do not conform to those stated on the motor's plate.
5. Machines operator has not checked condition of the drilling machine, condition of
power cable, control panel or cutter.
6. Power supply socket is not equipped with a protection circuit.
7. Machine is not secured with safety chain as a protection from falling down
especially when used at heights or in vertical or upside-down positions.
8. Bystanders are present in the immediate vicinity of machine.
Important rules of safe use of drilling machine
1)
Before attempting to work with the machine check condition of electrics including power
cord and plug.
2)
The drilling machine should be connected to an installation equipped with protection
circuit (neutral or ground) and protected with a 16 A fuse for 220V and 32 A fuse for
120V. When used on building sites, it must be supplied through a separation
transformer made in the second class of protection
3)
Machine can be used outdoors, but is not weatherproof. Do not expose to rain, snow or
frost.
4)
Machine should not be used on: rusty surfaces, steel plates with thick covered with
paint, uneven surfaces, next to a welding machine.
5)
In all cases always use a safety chain/strap /see drawing 1/. The safety chain mustn't
be loose! To avoid this situation the safety chain should be wrapped around the
element it is hooked to.
6)
Do not use the machine in explosion hazard zones.
7)
Do not start work if the machine has excessive play on guide slides.
8)
Always wear safety goggles and ear protection.
9)
Do not remove metal chips with bare hands.
Operator's manual for Drilling Machine MAGBEAST 2
MAGBEAST 2
- 3 -
Advertisement
Table of Contents
