JEI MAGBEAST 2 Safety Instructions And Operator's Manual page 7

JEI SOLUTIONS LTD
Installing and uninstalling the arbor
1.1
The arbor installation and uninstallation should be carried out when the machine
is turned off and disconnected from the power grid!
Installing the arbor:
a) Rice the guard (2) to the maximum,
b) Clean the inside of the spindle using a cotton cloth,
c) Before mounting, clean off the lubricant from the new arbor (3),
d) Place the arbor with the fin on top, and place it in the spindle,
e) By turning the arbor, align the fin to the appropriate slot in the spindle,
f) Using a light impact from the bottom side, drive the arbor into the spindle.
Uninstalling the arbor:
a) Raise the guard, turn the spindle so that the wedge MT opening in the spindle (1) is lined
up with the wedge MT opening in the reducer body,
b) Place the wedge MT (included as standard equipment) into the uncovered spindle
opening (1),
c) Hold down the arbor (3) with one hand,
d) Strike the wedge MT with a hammer, taking care to not to damage the arbor,
e) Carefully remove the arbor from the socket in the spindle,
f) Remove the wedge MT.
Operator's manual for Drilling Machine MAGBEAST 2
MAGBEAST 2
- 6 -