Clean The Parking Caps - 3D Systems ZPRINTER 650 Quick Start Manual

6.2 Empty The Debris Separator
The purpose of the Debris Separator is to keep any large parti-
cles from going back into the Feeder during vacuuming.
1. Pull the Debris Separator out
of its holder on the printer.
2. Empty the contents into a
trash receptacle.
3. Use the soft brush found in the
Accessory Kit to brush caked
on powder from the screen.
4. Return the empty Debris Sepa-
rator to its holder. Be sure to
push the Separator flat against
the panel for a secure fit.
3dscentral.3dsystems.com

6.3 Clean the Parking Caps

The Parking Caps keep the print heads from drying out between
print jobs. Cleaning the Parking Caps after every build results in
longer lasting print heads and precise accuracy during printing.
The Parking Caps are located on the right end of the Fast Axis.
Before you begin:
• Get several dry paper towels.
• Get the squirt bottle included in your Accessories Kit.
• Fill the squirt bottle with distilled water.
• Wear disposable gloves.
1. Pull the Fast Axis toward you and slide the Printhead Car-
riage to the left to expose the Parking Caps.
2. Lay paper towels
on the Build Bed
under and around
the Parking Caps.
Be sure to cover
the Front Over-
flow with paper
towels to keep
water out.
Parking Caps
(5 total)
13