11 ASSEMBLING THE MODULES .... CONTINUED
11. Remove 4 screws on each rear gas pipe support
channel and discard channels.
13. Tie support the thermistor harnesses on each boiler module.
The thermistor harness is located towards the rear of each
boiler module. Using the 4 tie wraps supplied in the casing
assembly pack, tie the harnesses to the 4 holes located on
the inside face of the rear support channel.
15. Fit master fascia panel securing with 2 x M4
screws. Ensure ribbon cable is re-fitted.
IMAX XTRA -
Installation & Servicing
INSTALLATION
12. Replace with the one piece rear gas pipe support channel and
secure with 6 screws (located in casing assembly pack).
14. Place top panel onto both modules and
secure at rear with 2 x M5 screws (supplied).
16. Fit Slave inner fascia panel to Slave Module securing with 2 x
M5 screws whilst re-fitting ribbon cable to display board.
15