Table of Contents
Advertisement
USERS GUIDE
LOGIC Combi E
E24, E30, E35
For installation guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
Advertisement
Table of Contents
Related Manuals for IDEAL Logic Combi E
Summary of Contents for IDEAL Logic Combi E
-
Page 1: Users Guide
USERS GUIDE LOGIC Combi E E24, E30, E35 For installation guide see reverse of book When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. -
Page 2: Reset
Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500. Ideal Stelrad Group is a member of the Benchmark scheme and fully supports the aims of the programme. Benchmark has been introduced to improve the standards of installation and commissioning of central heating systems in the UK and to encourage the regular servicing of all central heating systems to ensure safety and efficiency. -
Page 3: Operation
C, adjustable via the CH temperature control (C). Ensure the mode knob control (D) is set to winter ( The Logic Combi E is a high efficiency combination boiler which is The boiler will fire and supply heat to the radiators but will give most efficient when operating in condensing mode. -
Page 4: Loss Of System Water Pressure
The appliance should be serviced at least once a year by a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII). Closed position Open position caps Closed position continued ..Ideal Logic Combi E - User’s... -
Page 5: Troubleshooting
Contact a Gas Safe Registered is displayed then contact a Gas Engineer or in IE a Registered Safe Registered Engineer or in Gas Installer (RGII) IE a Registered Gas Installer (RGII) continued ..Ideal Logic Combi E - User’s... -
Page 6: Operation Modes
The boiler has a call for hot water but the appliance has reached the desired temperature set on the boiler. The boiler is operating in central heating mode. The boiler is operating in hot water mode. The boiler is operating in frost mode. continued ..Ideal Logic Combi E - User’s... -
Page 7: Fault Codes
Reset the appliance - if the boiler fails to operate then please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the warranty period. In IE contact a Registered Gas Installer (RGII). Ideal Logic Combi E - User’s... - Page 8 Ideal Consumer Helpline Ideal Stelrad Group pursues a policy of continuing improvement in the design and performance of its products. The right is therefore reserved to vary specification without notice. Tel: 01482 498660 Ideal, P.O. Box 103, National Ave, Kingston Upon Hull, HU5 4JN.