cectek Gladiator Service Manual page 53

5.The piston size mark on top
( A or B )
6.Confirm： when you face the
A
exhaust mark is in the down
side
7.Confirm：the connecting rod (1)
right side mark R is same side
8.Install one clip (3) into the
9.Install pin (2) into pin groove
10.Install the clip (3) into the
11.Then sequentially install parts
12.The opening of ring (8) of
46
piston , the piston (4,5)
of piston
piston clip groove firmly
other side groove to stop the
pin (2)
(8) , (7) , (6) , the crevice
position of each ring as figure
A shows
spacer shall be upward as
figure B shows