Operating Status Display - Siemens AT18 Operating Instructions Manual

Operating Manual - Elevator Door Operation AT18

11 Operating status display

The 7-segment display H5000 displays the following operating statuses:
Display Meaning
0 Light barrier signal is in place (light barrier interrupted)
1 RAM, EEPROM or CPU error (system error)
 EEPROM error
3 Error in the shut-off route
4 Increase of the hold open time at increased motor switch-on duration
5 Motor undefined*
6 Motor blocked in closing direction
7 Error pulse generator
Minimal editor is started (push service buttons OPEN and CLOSE at the same time)
8
9 Motor excess current
A Minimal editor (force setting) active
b Reserve
c Blockage at opening
C Minimal editor (profile setting) active
d Door stays standing during initialisation drive (no OPEN and CLOSE signal)
E Motor excess voltage
F Motor excess voltage
h Reserve
H Parameter determination (teach-in drive)
n Friction values of door too high
L Current measurement error
o Function OK
P Parameter error (error in teach-in drive)
u Door is closed
U Maximum door weight exceeded
- Controls wait for teach-in drive
* At the deployment of another motor type a renewed putting into operation according to this
operating manual must be done.
0